Electroosmotic dewatering of dredged sediments: bench-scale investigation

The Indiana Harbor (Indiana, USA) has not been dredged since 1972 due to lack of a suitable disposal site for dredged sediment. As a result of this, over a million cubic yards of highly contaminated sediment has accumulated in the harbor. Recently, the United States Army Corps of Engineers (USACE) has selected a site for the confined disposal facility (CDF) and is in the process of designing it. Although dredging can be accomplished rapidly, the disposal in the CDF has to be done slowly to allow adequate time for consolidation to occur. The sediment possesses very high moisture content and very low hydraulic conductivity, which cause consolidation to occur slowly. Consolidation of the sediment is essential in order to achieve adequate shear strength of sediments and also to provide enough air space to accommodate the large amount of sediment that requires disposal. Currently, it has been estimated that if a one 3-foot (0.9-m) thick layer of sediment was disposed of at the CDF annually, it would take approximately 10 years to dispose of all the sediment that is to be dredged from the Indiana Harbor. This study investigated the feasibility of using an electroosmotic dewatering technology to accelerate dewatering and consolidation of sediment, thereby allowing more rapid disposal of sediment into the CDF. Electroosmotic dewatering essentially involves applying a small electric potential across the sediment layer, thereby inducing rapid flow as a result of physico-chemical and electrochemical processes. A series of bench-scale electrokinetic experiments were conducted on actual dredged sediment samples from the Indiana Harbor to investigate dewatering rates caused by gravity alone, dewatering rates caused by gravity and electric potential, and the effects of the addition of polymer flocculants on dewatering of the sediments. The results showed that electroosmotic dewatering under an applied electric potential of 1.0VDC/cm could increase the rate of dewatering and consolidation by an order of magnitude as compared to gravity drainage alone. Amending the sediment with polymers at low concentrations (0.5-1% by dry weight) will enhance this dewatering process; however, the optimal polymer concentration and the cost-effectiveness of using polymers should be investigated further.     

安全评价方法在危险废物处置环境风险评价中的应用探讨

对安全评价方法在危险废物处置建设项目环境风险评价中的运用进行初步探索。主要用"工艺过程风险因素分析表"对工艺过程潜在风险性识别;用蒙德法进行源项分析;用池火灾模型、蒸气云爆炸伤害模型对易燃、易爆物质的火灾、爆炸等重大事故后果进行计算,得出人员的伤亡半径和财产损失半径等参数,以便于判断风险的可接受水平。分析结果表明:采用安全评价方法对危险废物处置建设项目进行环境风险评价是适用的、可行的。     

Immersion frying for the thermal drying of sewage sludge: an economic assessment

This paper presents an economic study of a novel thermal fry-drying technology which transforms sewage sludge and recycled cooking oil (RCO) into a solid fuel. The process is shown to have significant potential advantage in terms of capital costs (by factors of several times) and comparable operating costs. Three potential variants of the process have been simulated and costed in terms of both capital and operating requirements for a commercial scale of operation. The differences are in the energy recovery systems, which include a simple condensation of the evaporated water and two different heat pump configurations. Simple condensation provides the simplest process, but the energy efficiency gain of an open heat pump offset this, making it economically somewhat more attractive. In terms of operating costs, current sludge dryers are dominated by maintenance and energy requirements, while for fry-drying these are comparatively small. Fry-drying running costs are dominated by provision of makeup waste oil. Cost reduction could focus on cheaper waste oil, e.g. from grease trap waste.     

焦化废水处理过程中固相物质的形成及处置方法评价

焦化废水处理过程中产生的焦油、污泥和结晶杂盐等固相物质,既有资源属性,又有污染特性,但目前缺乏基于能源、经济及环境影响方面的评估.本研究阐述了3类固相物质的形成机制,建立了质量当量计算及处置方法评价模型.以宝武集团韶关钢铁股份有限公司焦化厂（二期）焦化废水处理工程的A/O/H/O（厌氧/好氧/水解/好氧）流化床工艺作为考察对象,利用工程运行参数和水质统计数据进行固相物质的产量推算,结果发现,焦油、物化污泥、生物污泥（含水率为80%）和工业杂盐的产率分别为0.186、5.80、4.24和1.97 kg·m^-3.通过处置方法评价模型明确了焦油焚烧、污泥热解、结晶杂盐分盐提纯后工业应用是最佳处置方案,在60 m³·h^-1废水处理规模的固相物质处置过程中,每年约产生1177 MWh的能源,获得135.0万元的经济效益,排放627.0 t CO₂,表明能源回收、经济效益和环境影响的协同存在.     

奎屯市区城市废水排污系统网络化的探讨

根据奎屯市区城市废水的排放量大、排污口多、污染物浓度高以及排污下水管道污水处理设施的建成现状等特点，提出了以污水处理厂为治理中心，市区排污管道网络化的改造设想、存在问题及对策。     

新疆番茄酱企业生产废水处理利用方式探析

近年来,新疆番茄酱加工业得到了迅速发展,目前番茄酱的产销量已占全国的90%以上。与此同时，新疆番茄酱生产企业的废水排放量也大幅增加,大量未经处理的废水直接排放,已对当地的水环境构成严重的污染隐患。本文分析了新疆番茄酱企业生产废水的排放特征与目前排放出路的可行性,并结合新疆的自然地理条件及番茄酱企业的分布情况，着重探讨了土地处理这一适合新疆的废水利用方式,以期有利于新疆的环境保护和废水资源的循环利用。     

混凝沉淀用于铬鞣废液处理方法的探讨

对制革生产废水中的铬鞣废液的处理方法进行了探讨，通过投加处理效率高且费用低廉的混凝剂提高废水中铬的去除效率，并最终应用于实际工程中，取得了良好的效果。     

发光细菌法评价工业废水的毒性

用发光细菌测定法估算了两城市污水对河道水体污染的分担率，评价了工厂排放废水的毒性，并据此确定了污染源监督管理中应优先治理的工厂（车间）废水。     

哈尔滨市生活垃圾处理产业化探讨

随着我国经济发展和人民生活水平的不断提高,城市垃圾产生量也不断增加,垃圾处理越来越受到人们的重视,垃圾处理产业也逐渐兴起.由于地区差异,工业发达程度和生活水平不同,不同的国家和地区有着不同的垃圾组成,相应的也采取不同的垃圾处理方法.哈尔滨市的生活垃圾处理现状具有一定的典型性,文章结合哈尔滨市实际情况,主要论述哈尔滨市生活垃圾的产量、特性及目前的处理状况,分析哈尔滨市生活垃圾问题的实质,对垃圾处理产业化存在的问题及其对策进行探讨,以期更好地促进生活垃圾处理步入产业化的发展轨道.     

重庆城市餐厨垃圾管理对策的初步研究

餐厨垃圾对环境的污染和人们身心健康的危害日益显现,重庆市对餐厨垃圾的统一管理与处置基本还处于空白状态.本文介绍了国内外餐厨垃圾管理的政策和措施,剖析重庆城市餐厨垃圾污染的现状及原因,进而提出全市餐厨垃圾管理的总体思路,并着重从健全法律法规体系、转变政府管理职能、建立市场化机制及引导公众参与等方面提出了相应的对策建议.